AITRIP 3PCS DRV8871 DC Motor H-Bridge DC Drive Breakout Board 6.5V-45V 3.6A MaxH-Bridge Brushed DC Motor Driver Breakout Board PWM Control for Arduino
Features: H-Bridge Motor Drive Module Drives One DC Motor, One Winding of a
Stepper Motor, or Other Loads Wide 6.5-V to 45-V Operating Voltage 565-m Ohm
Typical RDS(on) (HS + LS) 3.6-A Peak Current Drive PWM Control Interface
Current Regulation Without a Sense Resistor Low-Power Sleep Mode Small Package
and Footprint 8-Pin HSOP With Integrated Protection Features: VM Undervoltage
Lockout (UVLO) Overcurrent Protection (OCP) Thermal Shutdown (TSD) Automatic
Fault Recovery Package included: 3 x DRV8871 DC Motor Drive Modules
 
Product Features
  

         
DRV8871 DC Motor Drive Module for Brushed DC Motor; The DRV8871 device has advanced currentregulation circuitry that does not use an analog voltage reference or external sense resistor. This novel solution uses a standard low-cost, low-power resistor to set the current threshold. The ability to limit current to a known level can significantly reduce the system power requirements and bulk capacitance needed to maintain stable voltage, especially for motor startup and stall conditions.
         
RV8871 H-Bridge Brushed DC Motor Driver Breakout Board For Arduino PWM Control 3.6A Max Internal Current Sense 6.5V To 45V
         
The DRV8871 device is a brushed-DC motor driver for printers, appliances, industrial equipment, and other small machines. Two logic inputs control the Hbridge driver, which consists of four N-channel MOSFETs that can control motors bidirectionally with up to 3.6-A peak current. The inputs can be pulsewidth modulated (PWM) to control motor speed, using a choice of current-decay modes. Setting both inputs low enters a low-power sleep mode.
         
Application:Printers; Appliances; Industrial Equipment; Other Mechatronic Applications;
         
3.6A DC Motor H-bridge PWM Driver Module